Fully Specified Static Route: -
· we must specify the interface on where all packets are sent to the destination
network or the next-hop address in a fully specified in static route.
network or the next-hop address in a fully specified in static route.
· we can use a fully specified static route where the output interface is a multi-access area and you need to identify next-hop address.
· The next-hop address must be attached to the specified output interface.
Take a Look of Fully Specified Static Route Configuration: -
First Configure all ip address on all interface as this Diagram.
R1 Configuration: -
R1(Config)#ip route 30.0.0.0 255.0.0.0 f0/0 20.0.0.3
R1(Config)#ip route 2.2.2.2 255.255.255.255 f0/0 20.0.0.2
R2 Configuration: -
R2(Config)#interface Loopback 0
R2(Config-if) #ip address 2.2.2.2 255.255.255.255
R2(Config)#ip route 10.0.0.0 255.0.0.0 f0/0 20.0.0.1
R2(Config)#ip route 30.0.0.0 255.0.0.0 f0/0 20.0.0.3
R3 Configuration: -
R3(Config)#ip route 2.2.2.2 255.255.255.255 f0/1 20.0.0.2
R3(Config)#ip route 10.0.0.0 255.0.0.0 f0/1 20.0.0.1
Verify ip routing table: -
R1#sh ip route
2.0.0.0/32 is subnetted, 1 subnets
S 2.2.2.2 [1/0] via 20.0.0.2, FastEthernet0/0
C 20.0.0.0/8 is directly connected, FastEthernet0/0
C 10.0.0.0/8 is directly connected, FastEthernet0/1
S 30.0.0.0/8 [1/0] via 20.0.0.3, FastEthernet0/0
R2#sh ip route
2.0.0.0/32 is subnetted, 1 subnets
C 2.2.2.2 is directly connected, Loopback0
C 20.0.0.0/8 is directly connected, FastEthernet0/0
S 10.0.0.0/8 [1/0] via 20.0.0.1, FastEthernet0/0
S 30.0.0.0/8 [1/0] via 20.0.0.3, FastEthernet0/0
R3#sh ip route
2.0.0.0/32 is subnetted, 1 subnets
S 2.2.2.2 [1/0] via 20.0.0.2, FastEthernet0/1
C 20.0.0.0/8 is directly connected, FastEthernet0/1
S 10.0.0.0/8 [1/0] via 20.0.0.1, FastEthernet0/1
C 30.0.0.0/8 is directly connected, FastEthernet0/0
No hay comentarios:
Publicar un comentario